The problem is that it may remove the oxidation and introduce another problem that may make it difficult for your computer to see the RAM. Note that you need to remain cautious while rubbing the eraser on the RAM stick. Ensure they are well oriented by checking out the divider locations in their respective slots. Once the slots and RAM modules are free of debris and dust, you can open the clips and reinstall the modules. It will allow you to clean the RAM faster. Therefore, the best way to clean the contacts is to blow off the dust and pull out the RAM module. Do not use any solvent to clean the module contacts because the surface of your RAM is delicate and can quickly get damaged. Do not return the RAM in its slot before cleaning the RAM module contacts. The last thing you will need to do is to clean the RAM module contacts. Reinstall the battery and connect it to the source of power. Also, ensure to fill the bottom slot fast and install the RAM. Push it down a little bit until it is in the right place. Once you verify that it is clean, replace the RAM stick.Įnsure to insert the RAM back into its slot at an angle of 45 degrees. Continue blowing it out until there is no debris left. If you don’t do this, any remaining dust will fall back in the RAM slots. Notice that it is important to check and ensure that there is no dust debris left. Use a good source of light to help you check if they are clean. Blow the air into the slot and check and confirm that there is no debris left in the slots. The next thing you must do is clean the slots. You can then clean Ram sticks and the RAM slots. It helps to loosen and eraser fillings trapped in the heat spreaders. You may also tap the RAM on a flat surface at the bottom. You can do this by blowing compressed air across the RAM to remove the debris remaining on the contacts. Ensure there are no traces of eraser fillings on the contacts. Once you have cleaned the contacts, wipe them until they are smooth. Note that the cotton swab needs to be rubbed with alcohol and dried fast before using it. Use a cotton swab and a soft cloth to clean the eraser filling. Slide the RAM from the slot at an angle and hold the module by the edge. Push the latches down using your two fingers until the RAM pops up at an angle of 45 degrees. Hold the power button down for about 5-7 seconds to discharge any remaining charges.Ĭheck out the RAM stick icon to see where the RAM is on the motherboard. Alternatively, attach the alligator to any visible metal surface. Make use of the anti-static wrist strap to earth the charges. Touch the unpainted metal object to discharge accumulated charges. You can do this by sliding the latches on the battery case. So, you will need to be a bit cautious so that you don’t damage the RAM.Įnsure to remove the power cable before you remove the battery. There are cases where you may not easily remove the RAM. Remove the leads to allow you to access the RAM slot. It eliminates the chances of electrical shocks when handling the components. Touch the case using your finger to reduce the electric charges. Unplug the computer from the source of power and move it to open space. You may also clean a RAM stick by following the following steps. It ensures that the RAM fits perfectly in its space. Also, ensure to line the notches correctly and apply a bit of pressure on either side of the power cable. Once the RAM stick is dry, please return them to their bay. Also, use canned air to blow the RAM bay and dust the case out. Give the RAM some time to dry before you repeat the process on all the sticks. Also, use some piece of cloth so that you don’t leave any fiber on the sticks. But ensure to moisten the swab a bit by rubbing some alcohol. Repeat the process again but if there is any loose dust, blow it off using canned air. It is this dirt that makes it difficult for your computer to see the RAM. The first few strokes should result in a dirty erase, meaning that the RAM has picked plenty of dirt. You may also lay the RAM module on a flat surface and use a pencil eraser to clean the contacts. Use an eraser to clean the contact forth and back. Press the holding clip on the side of the RAM and eject it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |